Safety Interface Controller for Pressure-Sensitive Safety Mats, Edges, Bumpers and Switches
May 1, 2012Tapeswitch Corp., Farmingdale, NY, introduces its PSSR-2 safety interface controller for monitoring any safety switch, mat, edge, and bumper system product with an end-of-the-line resistor at a CAT3 PLd SIL2 safety level performance. Among its capabilities:
• Resistor monitoring
• IP20 protection rating safety controller
• Control unit is 22.5-mm DIN rail mountable
• Three output contacts; force-guided relays and two normally open (safety) 1 x normally closed (monitor) contacts
• Manual or auto reset
• CAT 3 PLd SIL2 performance level, EN 13849
Compared to four-wire products, the controller allows for less wiring and simplified installation, according to company officials.
Tapeswitch Corp.: 631/630-0442; www.tapeswitch.com
See also: Tapeswitch Corporation
Technologies: Safety
John Lynch Joins Saf-T-Gard as Senior Director of Business D...
Tuesday, March 22, 2022
Use of Alternative Methods to Control Hazardous Energy—In Li...
Ted Sberna Tuesday, December 28, 2021

Target on Safety: The Basics of Hazard Communication
Ronald Pitcher Monday, October 25, 2021

Ross Controls Moves to New Global Headquarters
Friday, September 17, 2021
Comments
Must be logged in to post a comment. Sign in or Create an Account
There are no comments posted.