Leveler Produces Dead-Flat Parts

October 1, 2009

Leveler Produces Dead-Flat Parts

Stop by the booth of Arku to watch its FlatMaster precision leveler produce dead-flat parts from laser- and flame-cut steel as thick as 2 in. The servo-hydraulic leveler features small roller spacing and roller diameter to eliminate residual stress in one pass. Hydraulic gap control ensures consistent results even when material cross-section changes. And, leveling rollers can be changed and the unit thoroughly cleaned in minutes.



See also: ARKU, Inc.

Technologies: Coil and Sheet Handling


Must be logged in to post a comment.
There are no comments posted.

Subscribe to the Newsletter

Start receiving newsletters.