Ohio Steel Processor Upgrades its Oscillated-Coil Capabilities

February 1, 2010

Specialty Strip & Oscillating, Inc., Masury, OH, has installed two new oscillators to improve its ability to provide oscillated coils of cold-rolled, low- or high-carbon, alloy or stainless-steel strip and sheet. New oscillator capabilities include face sizes from 4 to 14 in., width from 0.260 to 2.5 in., gauge from 0.009 in., welds annealed and ground, slit or deburred, straight-patterned coil walls and coiled on steel liners, fiber cores or spools.

Customers now can run a coil uninterrupted for 10 to 15 times longer than with conventional ribbon-wound coils, say company officials, eliminating downtime, coil-end scrap loss, and coil telescoping and tangling.

Specialty Strip & Oscillating provides oscillate coils with 20 to 25 miles of continuous strip that weigh as much as 5000 lb.

Industry-Related Terms: Annealed, Gauge, Run, Scrap
View Glossary of Metalforming Terms

 

See also: Specialty Strip & Oscillating, Inc.

Technologies: Coil and Sheet Handling

Comments

Must be logged in to post a comment.
There are no comments posted.

Subscribe to the Newsletter

Start receiving newsletters.