Logopress3 Blank Available for Autodesk Inventor

May 1, 2010

A new Logopress3 Blank software module allows manufacturers to use the finite-element-analysis flattening software during 3D modeling in Autodesk Inventor 2010 and 2011. The new module, from Logopress Corp., Besancon, France (represented in North America by Accurate Die Design, New Berlin, WI) can be used to determine the theoretical blank of a 3D formed part. It includes automatic meshing, and shows stress and strain and thinning and thickening.

Accurate Die Design, Inc.: 262/938-9316; www.accuratediedesign.com

Industry-Related Terms: Blank, Die
View Glossary of Metalforming Terms

Technologies: Management


Must be logged in to post a comment.
There are no comments posted.

Subscribe to the Newsletter

Start receiving newsletters.