Brad Kuvin Brad Kuvin
Editorial Director

Connectivity the Key to Unlocking Creativity

December 1, 2015

Intra-machine connectivity—where pieces of manufacturing equipment communicate amongst each other and can adjust, without human assistance, to changing conditions —has become reality. Case in point: Mazak, which has brought the Internet of Things to its factory in Florence, KY, and is ready to share its good fortunes with the manufacturing community it serves.

We caught a look at Mazak’s “smart factory” loaded with “smart machines” during its recent Discover 2015 technology/education event. There, through its partnerships with industry suppliers Memex (Merlin software) and Cisco (a secure networking platform), Mazak introduced its new SmartBox device. When mounted to a machine tool, the device uses the MTConnect communication protocol to enable enhanced monitoring and analytics, with state-of-the-art cybersecurity. For analytics, SmartBox, because it is a completely open standard, works in conjunction with numerous third-party analytical software platforms. Within its own manufacturing operations, Mazak opts for the Memex solution.

This concept elevates lean manufacturing to a whole new level. Mazak demonstrated the new digital-manufacturing strategy, dubbed the iSmart factory, on an automated four-machine cell. iSmart provides plant management with real-time visibility and insights into factory-floor operations. And, third-party personnel (your equipment supplier, for example) can securely log on to your network and access the data, too.

The impact of such grandiose connectivity and information flow reaches as far as the imagination can take it. Within the Mazak facility in Florence, plant management boasts of double-digit increases in machine utilization after using SmartBox devices for a little more than a year. That’s the low-hanging fruit, we’re told; continued significant operating efficiencies remain in play.

Lean machines are coming, and they can’t get here too quickly. I recently heard consultant Dick Kallage (KDC & Associates, Barrington, IL) spring this zinger on metalforming executives: The number of people required to operate a $10 million metal-fabricating shop will drop by 20 to 25 percent by 2020, and by 65 to 75 percent by 2025.

Yes, the “horsepower race” will continue, with equipment suppliers providing more power, workpiece capacity and operating speed than ever before. However, pay very close attention to intra-machine communication that promotes efficiency throughout the manufacturing process. This is where metalformers can make enormous progress in their efforts to eliminate waste.

Idle machines, regardless of their brawn, and idle manpower simply cannot be tolerated. For example, consider Aaron Wiegel, president of metalforming company Wiegel Tool Works, in Wood Dale, IL. Wiegel is on a personal mission to drive green-light time and efficiency throughout his pressroom and toolroom. With the help of Wintriss ShopFloorConnect asset-utilization software, Wiegel receives automated e-mails when any aspect of his operations fails to meet predetermined expectations. If an operator has, for example, 10 min. to complete a task and it’s taking too long, for whatever reason, Wiegel receives an automated alert e-mail, which gets him out of his seat and onto the shop floor.

We’ll tell you more about his mission in next month’s issue of MetalForming.

Industry-Related Terms: Case, E-Mail, Point
View Glossary of Metalforming Terms

Technologies: Bending, Management, Sensing/Electronics/IOT


Must be logged in to post a comment.
There are no comments posted.

Subscribe to the Newsletter

Start receiving newsletters.