Previews


 

SHARE:  

Transfer Parts and Remove Scrap from Under Press

Saturday, March 01, 2008
 
Bunting Magnetics, Newton, KS, will display its standard low-profile
MagSlide chip and parts conveyors
conveyors, which need less than 2 in. of vertical clearance to allow the removal of parts and scrap from presses and from other confined spaces. Where several of the conveyors are installed in tandem, a single motor can provide gang-drive power. Standard models are magnetic to provide continuous control of small- to-medium-sized ferrous parts and scrap; metalformers also can use nonmagnetic models.

Bunting also offers its MagSlide chip and parts conveyors (pictured here), built to convey sharp, abrasive ferrous parts and scrap that could damage conventional belt conveyors.

www.buntingmagnetics.com

 

See also: Bunting Magnetics Co.

Related Enterprise Zones: Automation


Reader Comments

There are no comments posted at this time.

 

Post a Comment

* Indicates field is required.

YOUR COMMENTS * (You may use html to format)

YOUR NAME *
EMAIL *
WEBSITE

 

 

Visit Our Sponsors